Pipe Fittings
2", ABS/DWV 45 Degree, Hub x Hub Ell, Used To Make A 45 Degree Turn From Another Fitting, For Non-Pressure Drain, Waste & Vent Installation, Low Chemical Resistance, Black Material.
3", ABS/DWV 45 Degree, 1/8 Bend Ell, Hub x Hub, Used To Make A 45 Degree Turn In A Waste Line, For Non-Pressure Drain, Waste & Vent Installation, Low Chemical Resistance, Black Material.
4" x 3", ABS/DWV Closet Flange Hub End, Used For Adapting Drainage System To Toilet At Floor Level, For Non-Pressure Drain, Waste & Vent Installation, Low Chemical Resistance, Black Material.
1-1/4", White, 90 Degree, Slip x Female Thread Ell, Used For Making A 90 Degree Turn In A Run Of Pipe, Used In Sprinkler & Irrigation Systems, Meets The Requirements Of ASTM D 2466.
1/2" White 90 Degree Street Elbow, Spigot x Slip, Used To Make A Right Angle Turn From Another Fitting, Used In Sprinkler & Irrigation Systems, Meets The Requirements Of ASTM D 2466.
1" White 90 Degree Street Elbow, Spigot x Slip, Used To Make A Right Angle Turn From Another Fitting, Used In Sprinkler & Irrigation Systems, Meets The Requirements Of ASTM D 2466.
3" x 3" Flexible Coupling With 2 Stainless Steel Clamps, Connects Cast Iron Or Plastic To Cast Iron Or Plastic.
2" White Cap Slip, Used To Cap Off The End Of A Pipe, Used In Sprinkler & Irrigation Systems, Meets The Requirements Of ASTM D 2466.
1-1/4" White 90 Degree Street Elbow, Spigot x Slip, Used To Make A Right Angle Turn From Another Fitting, Used In Sprinkler & Irrigation Systems, Meets The Requirements Of ASTM D 2466.